Babe Formula Whimsicle

Wet hair thoroughly with lukewarm water.

Apply a small amount of Shampoo and gently massage to create a rich lather.

Leave the shampoo on for 2–3 minutes—this gives the nourishing ingredients time to work.

Rinse thoroughly until no residue remains.

Remove excess water Gently squeeze out water so hair is damp, not dripping.

Apply conditioner Distribute a generous amount evenly through the mid-lengths to ends of your hair.

Let it sit: Leave it on for 3–5 minutes to deeply moisturize and nourish.

Rinse well: Rinse thoroughly with lukewarm water until all residue is gone.

Finish off softly: Towel-dry gently, then proceed with your usual blow-dry or air-dry routine.

water, Sodium Lauroyl Sarcosinate, Lauryl Glucoside, Cocamidopropyl Betaine, Cocamide DEA, Propylene Glycol, Fragrance, Polyquaternium‑10, Citric Acid, Phenoxyethanol, Ethylhexylglycerin, Aloe Vera Extract, D‑Panthenol, Argan Oil, Hydrolyzed Keratin (Quaternium‑79), and CI 60730.

 For the most accurate and detailed ingredient information, please refer to the product packaging or label.

This shampoo and conditioner are intended for external use only. Avoid contact with eyes and mucous membranes. In case of contact, rinse thoroughly with water. Discontinue use immediately if irritation, redness, rash, or other adverse reaction occurs, and seek medical advice if necessary. Keep out of reach of children. Individual results may vary depending on hair type, condition, and proper use. This product is not intended to diagnose, treat, cure, or prevent any disease or medical condition. Use only as directed. Store in a cool, dry place away from direct sunlight. Manufacturer and seller disclaim any liability for misuse or failure to follow product instructions.

The AAD recommends the following steps for patch testing a new skin care product:

1. Apply the product to a small patch of skin where a person is unlikely to accidentally wash or rub it away. Good areas may include the inside of the arm or bend of the elbow.
2. Apply the product to a quarter-sized patch of skin. A person should apply the product as thickly as they would when using it regularly.
3. Leave the product on the patch of skin for as long as it would normally be on the skin. If a person is testing a product that they would usually wash off, such as a cleanser, they should keep the patch on for 5 minutes or as long as the instructions advise.
4. Repeat the patch test twice a day for between 7–10 days. A reaction may not happen immediately, so it is important to continue applying the product for this length of time.
5. If a person’s skin reacts to the product, they should wash it off as soon as possible and stop using it. A person can use a cool compress or petroleum jelly to relieve the skin if needed.

Skin care products may contain many different ingredients. Some of these ingredients can irritate a person’s skin or even cause an allergic reaction. By performing a patch test on a small area of skin, a person can see how their skin tolerates a product before committing to using the product over a larger area.